It's fairly simple. A 1" dowel rid sits inside of a piece of PVC pipe. The pipe is clamped across one of the corners of the workbench and sticks out a few inches at each end.
At the front end, a corner brace is attached to the dowel using a couple of clevis pins and a hose clamp to keep thing nice and snug. The corner brace is bolted to either the neck or the body using the bolt-on neck joint.
At the other end of the dowel, another clamp tightens it down to the workbench to keep it from spinning when there is a load on it.
Finally there is a set of locking pliers attached to the end of the dowel to act as a handle to make it easier to rotate the work piece.
No comments:
Post a Comment